Quick Start Guide: matte Box adapter for GRIP RIg 2

Unboxing & Overview

In the Box

Matte Box/82mm Filter Adapter (95/115mm)

2x Embedded 1/4-20 Screws

What You Need

Grip Rig 2 (the adapter mounts to the top of the handles)

DJI Osmo Pocket 3

95 mm or 115 mm clamp matte box or 82 mm filter/accessory

important to know (Read first)

The adapter creates a short “tunnel.” You may see the edges of the opening in your shot if the camera isn’t centered or during extreme moves—this is normal.

Best for stationary shots. Moving shots can work if set up correctly (see tips below).

No whip pans or very fast moves with the adapter attached.

Battery handle is not compatible with the adapter attached.

How to Install

Mount the adapter
Place it on top of the Grip Rig 2 handles. Insert the two 1/4-20 screws and tighten with a 3 mm tool. Snug—don’t over-tighten.
Seat the camera
Gently slide the Pocket 3 gimbal into the ultrasuede hood until fully seated. Attach your camera to quick release.
Add your front accessory
Attach your 95 mm/115 mm matte box or any 82 mm filter/accessory.
Power on & check clearance
Turn on the Pocket 3 and make sure the gimbal moves freely without touching the adapter or accessory.

Tips for best results (especially when moving)

Set the Pocket 3 to Follow Mode → Follow Speed: FAST. (Normal is okay; Slow usually isn’t.)
Keep the adapter level with the ground while you frame and move around.
If the camera drifts off-center, double-tap the Thumb Controller to re-center. Hold the rig level while it recenters.

Mounting options

There’s a 1/4-20 port on the bottom of the adapter for a tripod or quick-release plate.

Quick troubleshooting

Edges in frame: Re-center (double-tap), keep the rig level, or slow down your move.
Gimbal bumps on start-up: Remove/adjust the front accessory and re-seat the camera, then power cycle.
Adapter feels loose: Re-snug both 1/4-20 screws (3 mm tool).

Any issues or questions please start a chat on the store!